next up previous contents index
Next: Pulse trains Up: Designer spectra Previous: Designer spectra   Contents   Index


Carrier/modulator model

In the previous chapter (see figure 5.4, page [*]), we showed how to use ring modulation to modify the spectrum of a periodic signal, placing spectral peaks in specified locations. To do so we need to be able to generate periodic signals whose spectra have maxima at DC and fall off monotonically with increasing frequency. If we can make a signal with a formant at frequency zero--and no other formants besides that one--we can use ring modulation to displace the formant to any desired harmonic. The ring modulation product will be of the form

\begin{displaymath}
x[n] = \cos(\omega_c n) f (a \cos(\omega_m n))
\end{displaymath}

where $\omega_c$ (the carrier frequency) is set to the formant center frequency and $f (a cos(\omega_m n))$ is a signal with fundamental frequency $\omega_m$, produced using a waveshaping function $f$ and index $a$. This second term is the signal we wish to give a formant at DC with a controllable bandwidth. A block diagram for synthesizing this signal is shown in Figure 6.2.

Figure 6.2: Ring modulated waveshaping for formant generation
\begin{figure}\psfig{file=figs/fig06.02.ps}\end{figure}

Much earlier in section 2.4 we introduced the technique of timbre stretching, as part of the discussion of wavetable synthesis. This technique, which is capable of generating complex, variable timbres, can be fit into the same framework. The enveloped wavetable output for one cycle is:

\begin{displaymath}
x(\phi) = T (c \phi) * W (a \phi),
\end{displaymath}

where $\phi$, the phase, satisfies $-\pi \le \phi \le \pi$. Here $T$ is a function stored in a wavetable, $W$ is a windowing function, and $c$ and $a$ are the wavetable stretching and a modulation index for the enveloping wavetable. Figure 6.3 shows how to realize this in block diagram form. Comparing this to figure 2.7, we see that the only significant new feature is the addition of an index to the waveshaping function.

In this setup, as in the previous one, the first term specifies the placement of energy in the spectrum--in this case, with the parameter $c$ acting to stretch out the wavetable spectrum. This is the role that was previously carried out by the choice of ring modulation carrier frequency $\omega_c$.

Figure 6.3: Wavetable synthesis generalized as a variable spectrum generator
\begin{figure}\psfig{file=figs/fig06.03.ps}\end{figure}

Both of these (ring modulated waveshaping and stretched wavetable synthesis) can be considered as particular cases of a more general approach which is to compute functions of the form,

\begin{displaymath}
x[n] = c(\omega n) {m_a}(\omega n)
\end{displaymath}

where $c$ is a periodic function describing the carrier signal, and ${m_a}$ is a periodic modulator function which depends on an index $a$. The modulation functions we're interested in will usually take the form of pulse trains, and the index $a$ will control the width of the pulse; higher values of $a$ will give narrower pulses. In the wavetable case, the modulation function must reach zero at phase wraparound points to suppress any discontinuities in the carrier function when the phase wraps around. The carrier signal will give rise to a single spectral peak (a formant) in the ring modulated waveshaping case; for wavetables, there may be a much more complicated spectrum.

In the next section we will further develop the two forms of modulating signal we've introduced here, and in the following one we'll look more closely at the carrier signal.


next up previous contents index
Next: Pulse trains Up: Designer spectra Previous: Designer spectra   Contents   Index
Miller Puckette 2005-04-01