Patch A05.output.subpatch.pd, whose active ingredients are shown in Figure 1.11(c), presents three Sinusoids with frequencies in the ratio 4:5:6, so that the lower two are separated by a major third, the upper two by a minor third, and the top and bottom by a fifth. The lowest frequency is 440, equal to A above middle C, or MIDI 69. The others are approximately four and seven half-steps higher, respectively. The three have equal amplitudes.
The amplitude control in this example is taken care of by a new object called
output~. This isn't a built-in object of Pd, but is itself a Pd patch
which lives in a file, output.pd. You can see the internals of
output by right-clicking on the box and selecting ``open". You get
two controls, one for amplitude in dB (100 meaning ``unit gain"), and a
``mute" button. Pd's audio processing is turned on automatically when you
set the output level--this might not be the right behavior in general, but
it's appropriate for these example patches. The mechanism for embedding one
Pd patch as an object box inside another is discussed in section
4.7.